Ad
related to: bosch jetronic ecu wiring diagram manual blue red paint chart home depotsmartholidayshopping.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
In the mid-1980s, Lucas developed the 13CU system by revising the Bosch L-Jetronic system and adding an electronic diagnostics capability to comply with California Air Resources Board requirements. The design of the 13CU also deviated from the original L-Jetronic design in that it used a hot-wire air mass sensor rather than the Jetronic's ...
The ECU was much cheaper to produce due to more modern components, and was more standardised than the L-Jetronic ECUs. As per L-Jetronic, a vane-type airflow sensor is used. [4] Compared with L-Jetronic, the fuel injectors used by LE-Jetronic have a higher impedance. [5] Three variants of LE-Jetronic exist: LE1, the initial version.
A Digifant II DF-1 Engine Control Unit used in '91 Volkswagen Golf Cabriolet with 2E engine. Digifant is an Engine Management System operated by an Engine Control Unit that actuates outputs, such as fuel injection and ignition systems, using information derived from sensor inputs, such as engine speed, exhaust oxygen and intake air flow. [1]
Mid 1980s JECS LH-Jetronic ECU. 40 pin IC bottom left is Hitachi Motorola 6800 clone, 28 pin IC (socketed) immediately right is 16kB ROM containing maps. JECS logo bottom left. Bosch first produced the Jetronic EFI system in 1967. K-Jetronic & L-Jetronic followed from around 1973 [6] which is when Nissan became involved.
Bosch developed their D-Jetronic (D for Druckfühlergesteuert, German for "pressure-sensor-controlled"), from the Electrojector, which was first used on the VW 1600TL/E in 1967. This was a speed/density system, using engine speed and intake manifold air density to calculate "air mass" flow rate and thus fuel requirements.
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
An engine control unit (ECU), also called an engine control module (ECM), [1] is a device that controls various subsystems of an internal combustion engine. Systems commonly controlled by an ECU include the fuel injection and ignition systems.
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...