When.com Web Search

  1. Ads

    related to: water shut off valves stuck in sink drain cap replacement ideas

Search results

  1. Results From The WOW.Com Content Network
  2. Isolation valve - Wikipedia

    en.wikipedia.org/wiki/Isolation_valve

    These valves are normally left open so that the user can control the flow of water with the spigot above the sink, and does not need to reach under the counter to start or stop the water flow. However, if the spigot needs to be replaced (i.e. maintenance needs to take place on the system), the isolation valves are shut to stop the flow of water ...

  3. How to Clear a Clogged Sink Drain - AOL

    www.aol.com/clear-clogged-sink-drain-151500237.html

    Remove the plunger and observe whether the water drains. Repeat until the water drains. If you have a double sink, you’ll need to cover one of the drains while you plunge the other, says ...

  4. Air gap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Air_gap_(plumbing)

    This "air gap" is visible above the sink as a small cylindrical fixture mounted near the faucet. In the base cabinet under the sink, the drain hose from the dishwasher feeds the "top" of the air gap, and the "bottom" of the air gap is plumbed into the sink drain below the basket, or into a garbage disposal unit. When installed and maintained ...

  5. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    A trap primer automatically injects water into a trap, maintaining a water seal to keep sewer gas out of buildings. It must be installed in an easily accessible place for adjustment, replacement, and repair. A trap primer, a specialized valve, is usually connected to a clean-water supply in addition to a DWV system. [20]

  6. Tap (valve) - Wikipedia

    en.wikipedia.org/wiki/Tap_(valve)

    A single temperature tap is commonly found in a commercial or public restroom where the temperature of the water will be controlled by a separate temperature regulating valve that mixes hot and cold water. The regulating valve may be under the handwashing sink or in a separate mechanical room or service closet.

  7. Automatic bleeding valve - Wikipedia

    en.wikipedia.org/wiki/Automatic_bleeding_valve

    The top has a small outlet, usually hidden beneath a plastic dust cap. Internally there is a large hollow body, normally filled with water, and containing a float valve. The valve must always be installed vertically, usually at the top of a short vertical pipe. If the valve body is filled with water, the float moves upwards and closes the valve.

  1. Ad

    related to: water shut off valves stuck in sink drain cap replacement ideas