Search results
Results From The WOW.Com Content Network
Wire removal is a visual effects technique used to remove wires in films, where the wires are originally included as a safety precaution or to simulate flying in actors or miniatures. It uses a lot of rotomatting, a process of using splines in a program like After Effects or Nuke to extract a subject from a video, motion tracking, and painting ...
Sony proprietary. Combines composite video, S-Video, RGsB/YP B P R (both use same pins) and stereophonic sound (two analog channels). Used for all analog audio and video out on for the PlayStation, PlayStation 2 and PlayStation 3 video game consoles. (A few early original PlayStation models featured RCA outs for composite video and stereo ...
Screw terminals, as individual connectors to a board at left, as a barrier strip with setscrews at top, and as a barrier strip with attached spade and loop lugs at bottom. A screw terminal is a type of electrical connection where a wire is held by the tightening of a screw.
Terminal symbol A terminal strip, to which wires can be soldered. A terminal is the point at which a conductor from a component, device or network comes to an end. [1] Terminal may also refer to an electrical connector at this endpoint, acting as the reusable interface to a conductor and creating a point where external circuits can be connected.
Bullet terminals, male and female (right-center, with blue wires) A blade connector is a type of single wire, plug-and-socket connection device using a flat conductive blade (plug) that is inserted into a receptacle. Wires are typically attached to male or female blade connector terminals by either crimping or soldering. Insulated and ...
The terminal must be placed into the appropriately sized crimp barrel. The wire is then inserted into the terminal with the end of the wire flush with the exit of the terminal to maximize cross-sectional contact. Finally, the handles of the crimp tool are used to compress and reshape the terminal until it is cold-welded onto the wire. [3]
When engaged, a compound automatic wire stripper first simultaneously grips the wire in one side and in the other side closes its shaped blades cutting the insulation around the conductor. After the sides have completed their strokes the two sides of the mechanism spread apart to push the cut tube of insulation from the end of the conductor.
Video cameras are mostly based on the protocol AV/C. It defines the flow of audio and video data, as well as the camera's control signals. The majority of video cameras only provides the output of audio and video data via the FireWire bus ("DVout"). Additionally, some video cameras are able to record audio and video data ("DVout/DVin").