Ad
related to: difference between blade and vane steering damper assembly system in china
Search results
Results From The WOW.Com Content Network
A more sophisticated system called the vane gear was later devised, it relied on a small vane or airfoil driving the main rudder via an adjustable system of clockwork gears. It was very similar to the later vane driven autopilots seen on transatlantic yachts such as Blondie Hasler 's self steering rudder.
The steering damper or steering stabiliser is a damping device designed to inhibit an undesirable, uncontrolled movement or oscillation of a vehicle steering mechanism, a phenomenon known in motorcycling as the death wobble. The stabilizer absorbs unwanted energy in the side to side motion allowing the forks and shocks to work properly.
A steering column may also perform the following secondary functions: energy dissipation management in the event of a frontal collision; provide mounting for: the multi-function switch, column lock, column wiring, column shroud(s), transmission gear selector, gauges or other instruments as well as the electro motor and gear units found in EPAS and SbW systems;
A less common type of dashpot is an eddy current damper, which uses a large magnet inside a tube constructed of a non-magnetic but conducting material (such as aluminium or copper). Like a common viscous damper, the eddy current damper produces a resistive force proportional to velocity. A common use of the eddy current damper is in balance scales.
With a beam axle, the camber angle between the wheels is the same regardless of its location in the travel of the suspension. A beam axle's location in the fore and aft directions is constrained by one of several suspension components, including trailing arms , semi-trailing arms, radius rods, and leaf springs .
Spindles or uprights - Jaguar left and Holden Gemini right The wheel spindle in the illustration is colored red. In an automobile, the wheel spindle, sometimes called simply the spindle, is the part of the suspension system that carries the hub for the wheel and attaches to the upper and lower control arms.
In many racing cars, the springs and dampers are relocated inside the bodywork. The suspension uses a bellcrank to transfer the forces at the knuckle end of the suspension to the internal spring and damper. This is then known as a "push rod" if bump travel "pushes" on the rod (and subsequently the rod must be joined to the bottom of the upright ...
This was achieved by making the linkage not a simple parallelogram, but by making the length of the track rod (the moving link between the hubs) shorter than that of the axle, so that the steering arms of the hubs appeared to "toe out". As the steering moved, the wheels turned according to Ackermann, with the inner wheel turning further. [3]