Search results
Results From The WOW.Com Content Network
Boiling water reactors generally have negative void coefficients, and in normal operation the negative void coefficient allows reactor power to be adjusted by changing the rate of water flow through the core. The negative void coefficient can cause an unplanned reactor power increase in events (such as sudden closure of a streamline valve ...
The Reactor Protection System (RPS) is a system, computerized in later BWR models, that is designed to automatically, rapidly, and completely shut down and make safe the Nuclear Steam Supply System (NSSS – the reactor pressure vessel, pumps, and water/steam piping within the containment) if some event occurs that could result in inadvertant criticality.
The pressure potential in a plant cell is usually positive. In plasmolysed cells, pressure potential is almost zero. Negative pressure potentials occur when water is pulled through an open system such as a plant xylem vessel. Withstanding negative pressure potentials (frequently called tension) is an important
The GE Mark III Containment-system is a single barrier pressure containment and multi-barrier fission containment system, consisting of the containment vessel plus associated dry- and wetwell (pressure and fission barriers), the external shield building of it, the auxiliary building and the fuel building, all of which are normally kept at ...
The reactor pressure vessel is manufactured from ductile steel but, as the plant is operated, neutron flux from the reactor causes this steel to become less ductile. Eventually the ductility of the steel will reach limits determined by the applicable boiler and pressure vessel standards, and the pressure vessel must be repaired or replaced ...
As opposed to PWR, there is no separation between the reactor pressure vessel (RPV) and the steam turbine in BWR. Water is allowed to vaporize directly inside of the reactor core (at a pressure of approximately 70 bars) before being directed to the turbine which drives the electric generator. Immediately after the turbine, a heat exchanger ...
The High Pressure Coolant Injection (HPCI) System consists of a pump or pumps that have sufficient pressure to inject coolant into the reactor vessel while it is pressurized. It is designed to monitor the level of coolant in the reactor vessel and automatically inject coolant when the level drops below a threshold.
The resulting pressure increase inside the containment, which is designed to withstand the pressure, triggers containment sprays ("dousing sprays") to turn on to condense the steam and thus reduce the pressure. A SCRAM ("neutronic trip") initiates very shortly after the break occurs. The safety systems close non-essential lines into the air ...