Ads
related to: generator tool box combo ball bearing 1
Search results
Results From The WOW.Com Content Network
The ball bearing lets the flex spline rotate independently to the wave generator's shaft. The circular spline is a rigid circular ring with teeth on its inside. The flex spline and wave generator are placed inside the circular spline, meshing the teeth of the flex spline and the circular spline. Because the flex spline is deformed into an ...
A cannon bearing or cannon box bearing is an arrangement of bearings on a shaft, usually an axle, where two bearings are mounted in an enclosed tube. The function of the cannon box is to preserve the alignment of the two bearings, even if the overall tube is allowed to move. The two bearings will retain their same relative position.
The bearings have to be leak-tight. A hermetic seal, usually a liquid seal, is employed; a turbine oil at pressure higher than the hydrogen inside is typically used. A metal, e.g. brass, ring is pressed by springs onto the generator shaft, the oil is forced under pressure between the ring and the shaft; part of the oil flows into the hydrogen side of the generator, another part to the air side.
As an example, a 250 kVA motor–generator operating at 300 ampere of full load current will require 1550 ampere of in-rush current during a re-closure after 5 seconds. This example used a fixed mounted flywheel sized to result in a 1 ⁄ 2 Hz per second slew rate. The motor–generator was a vertical type two-bearing machine with oil-bath ...
Ordnance crest "WHAT'S IN A NAME" - military education about SNL. This is a historic (index) list of United States Army weapons and materiel, by their Standard Nomenclature List (SNL) group and individual designations — an alpha-numeric nomenclature system used in the United States Army Ordnance Corps Supply Catalogues used from about 1930 to about 1958.
The geometry of the way can vary depending on the situation. The most common types are flat, vee, and dovetail ways. Flat ways are used when there is little requirement for the slide to be constrained perpendicular to the axis of movement, or the constraint is being provided by another component or otherwise not needed, such as on the carriage of a lathe.