Ads
related to: das kit throttle assembly replacement parts diagram 10 ampsummitracing.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
1930 Ford Model A woody panel van engine. An updraft carburetor feeds intake manifold on engine's right side. Linkages control throttle, mixture, and choke. Normally, the Model A engine was supplied with a Zenith one-barrel, up-draft, float-type carburetor, which was gravity-fed from a tank in the engine cowl (between firewall and dash).
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
It is usually installed right behind the throttle valve in the throttle body. Single-point injection was a relatively low-cost way for automakers to reduce exhaust emissions to comply with tightening regulations while providing better "driveability" (easy starting, smooth running, freedom from hesitation) than could be obtained with a carburetor.
Sheetmetal stamped parts & blanks for various GM models: 1956 Located at 2400 West Second St. Metal fabricating. Originally a Fisher Body division plant. Mogi das Cruzes: Mogi das Cruzes, São Paulo state: Brazil: Stampings for new & replacement parts: 1999 Stamping plant 4: Orion Assembly: Orion Township, Michigan: United States: Chevrolet ...