Search results
Results From The WOW.Com Content Network
In aerodynamics, the lift-to-drag ratio (or L/D ratio) is the lift generated by an aerodynamic body such as an aerofoil or aircraft, divided by the aerodynamic drag caused by moving through air. It describes the aerodynamic efficiency under given flight conditions. The L/D ratio for any given body will vary according to these flight conditions.
The ratio of the distance forwards to downwards is called the glide ratio. The glide ratio (E) is numerically equal to the lift-to-drag ratio under these conditions; but is not necessarily equal during other manoeuvres, especially if speed is not constant. A glider's glide ratio varies with airspeed, but there is a maximum value which is ...
An ASH 31 glider with very high aspect ratio (AR=33.5) and lift-to-drag ratio (L/D=56) In aeronautics, the aspect ratio of a wing is the ratio of its span to its mean chord. It is equal to the square of the wingspan divided by the wing area. Thus, a long, narrow wing has a high aspect ratio, whereas a short, wide wing has a low aspect ratio. [1]
The tangent defines the minimum glide angle, for maximum range. The peak of the curve indicates the minimum sink rate, for maximum endurance (time in the air). Without power, a gliding aircraft has only gravity to propel it. At a glide angle of θ, the weight has two components, W.cos θ at right angles to the flight line and W.sin θ parallel ...
The logarithmic term with weight ratios is replaced by the direct ratio between / = where is the energy per mass of the battery (e.g. 150-200 Wh/kg for Li-ion batteries), the total efficiency (typically 0.7-0.8 for batteries, motor, gearbox and propeller), / lift over drag (typically around 18), and the weight ratio / typically around 0.3.
Glide slope is the distance traveled for each unit of height lost. In a steady wings-level glide with no wind, glide slope is the same as the lift/drag ratio (L/D) of the glider, called "L-over-D". Reducing lift from the wings and/or increasing drag will reduce the L/D allowing the glider to descend at a steeper angle with no increase in airspeed.
How to calculate the current ratio. You can calculate the current ratio by dividing a company’s total current assets by its total current liabilities. Again, current assets are resources that ...
So, the main reason for decreasing the blade section thickness to chord ratio is to delay the compressibility effect related to higher Mach numbers, delaying the onset of a shock wave formation. The natural outcome of this requirement is a wing design that is thin and wide, which has a low thickness-to-chord ratio.