Ads
related to: millermatic 211 inlet wire guide link meter medtronic
Search results
Results From The WOW.Com Content Network
Medtronic operational headquarters in Fridley, Minnesota, a suburb of Minneapolis. Medtronic was founded in 1949 in Minneapolis by Earl Bakken and his brother-in-law, Palmer Hermundslie, as a medical equipment repair shop. [8] Bakken invented several medical technology devices that continue to be used around the world today. [citation needed]
Guy-wire, a tensioned cable providing structural support, sometimes incorrectly called "guide wire" Topics referred to by the same term This disambiguation page lists articles associated with the title Guide wire .
The term SCR was part of a nomenclature system developed for the U.S. Signal Corps, used at least as far back as World War I.Three-letter designators beginning with "SC" were used to denote complete systems, while one and two-letter designators (such as "BC", for basic component, "FT" for mounting, etc.) were used for components.
Miller Electric is an American arc welding and cutting equipment manufacturing company based in Appleton, Wisconsin.Miller Electric, has grown from a one-man operation selling products in northeastern Wisconsin to what is today one of the world's largest manufacturers of arc welding and cutting equipment.
Post-World War II hospitals were just starting to employ electronic equipment, but did not have staff to maintain and repair them. Sensing an opportunity, with his brother-in-law, Palmer Hermundslie, he formed Medtronic (a portmanteau of "medical" and "electronic") in a small garage, primarily working with the University of Minnesota hospital.
This is because wavelength is inversely proportional to frequency (wavelength in metres = 299,792,458 / frequency in Hz), and transmitter efficiency is severely degraded if the length of the antenna is shorter than 1/4 wavelength. They used grounded or insulated guyed masts with umbrella antennas, or wire-spans across both valleys and fjords.
IEC 61107 or currently IEC 62056-21, was an international standard for a computer protocol to read utility meters. It is designed to operate over any media, including the Internet. A meter sends ASCII (in modes A..D) or HDLC (mode E) data to a nearby hand-held unit (HHU) using a serial port.
For example, if the meter is set to a range of 300 V full scale, the meter's impedance will be 6 MΩ. 20,000 Ω/V is the best (highest) sensitivity available for typical analog multimeters that lack internal amplifiers. For meters that do have internal amplifiers (VTVMs, FETVMs, etc.), the input impedance is fixed by the amplifier circuit.