Ads
related to: replacement trailer spring bushing tool setup chart for 4 gauge pipe
Search results
Results From The WOW.Com Content Network
Simple diagram of a drilling rig and its basic operation. The kelly drive is #19. A kelly drive is a type of well drilling device on an oil or gas drilling rig that employs a section of pipe with a polygonal (three-, four-, six-, or eight-sided) or splined outer surface, which passes through the matching polygonal or splined kelly (mating) bushing and rotary table.
A drill bushing, also known as a jig bushing, [1] is a tool used in metalworking jigs to guide cutting tools, most commonly drill bits. Other tools that are commonly used in a drill bushing include counterbores, countersinks, and reamers. They are designed to guide, position, and support the cutting tool. [2]
For a taper thread, it is the diameter at the "gauge length" (plus/minus one thread pitch) from the small end of the thread. The taper is 1:16, meaning that for each 16 units of measurement increase in the distance from the end, the diameter increases by 1 unit of measurement.
Figure 2: Martin mainspring slit gauge. Actual size 87 x 17 mm. A better method for measuring strength is to use a slit gauge, Figure 2, with which the thickness of the mainspring is measured directly. This gauge uses a scale of sizes running from 21 (0.05 mm) to 5/0 (0.30 mm). Scales used in watchmaking generally do not use negative numbers.
Bushing (bearing), a type of plain bearing; Bushing (electrical), an insulated device that allows a conductor to pass through a grounded conducting barrier; Bushing (isolator), a mechanical device used to reduce vibrational energy transfer between two parts; Drill bushing, a tool used to guide the placement of a hole when drilling in a workpiece
The leaf spring acts as a linkage to hold the axle in position and thus separate linkages are not necessary. The result is a suspension that is simple and strong. Inter-leaf friction dampens the spring's motion and reduces rebound, which, until shock absorbers were widely adopted, was a very significant advantage over helical springs. [4]