When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Tire code - Wikipedia

   en.wikipedia.org/wiki/Tire_code

   Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [29] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.

3. Tire uniformity - Wikipedia

   en.wikipedia.org/wiki/Tire_uniformity

   Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...

4. Tire load sensitivity - Wikipedia

   en.wikipedia.org/wiki/Tire_load_sensitivity

   Tire load sensitivity describes the behaviour of tires under load. Conventional pneumatic tires do not behave as classical friction theory would suggest. The load sensitivity of most real tires in their typical operating range is such that the coefficient of friction decreases as the vertical load, Fz, increases. The maximum lateral force that ...

5. Uniform Tire Quality Grading - Wikipedia

   en.wikipedia.org/wiki/Uniform_Tire_Quality_Grading

   [2] Light truck tires are not required to have a UTQG. It is not to be confused with the tire code, a supplemental and global standard measuring tire dimensions, load-bearing ability and maximum speed, maintained by tire industry trade organizations and the International Organization for Standardization.

6. ISO 5775 - Wikipedia

   en.wikipedia.org/wiki/ISO_5775

   The overall diameter of the tire is then the rim diameter plus twice the tire's section height. The ISO 5775-1 standard also defines procedures for measuring tires and for calculating from the marking the maximum dimensions of a tire, which are needed by designers to determine clearance distances to other bicycle components.

7. Load path analysis - Wikipedia

   en.wikipedia.org/wiki/Load_path_analysis

   a): load paths based on U* index; b): von Mises stress distribution [2] In the image to the right, a structural member with a central hole is placed under load bearing stress. Figure (a) shows the U* distribution and the resultant load paths while figure (b) is the von Mises Stress distribution. As can be seen from figure (b), higher stresses ...