Ads
related to: bbc 5 inch stroke crankshaft cylinder valve gasket replacement water pump
Search results
Results From The WOW.Com Content Network
The engine had MPFI (multi-port fuel injection), which gave slightly more power and better fuel economy, and two valves per cylinder. The engine had a bore and stroke of 4 + 1 ⁄ 4 in × 4 in (108.0 mm × 101.6 mm), producing 290 hp (216 kW) at 4000 rpm and 410 lb⋅ft (556 N⋅m) at 3200 rpm. It was used by Mercury Marine, named the ...
The 1976 to 1977 the engine received a new cylinder-head design, incorporating hydraulic lifters to replace the taper-screw valve adjusters, improved coolant pathways, longer-life valve-stem seals, a redesigned water pump and thermostat, and a five-year, 60,000-mile (97,000 km) engine warranty. The engine's name was changed to Dura-Built 140.
During the latter years of production, 379-and-432-cubic-inch (6.2 and 7.1 L) versions with enlarged crankshaft journals were manufactured as well. GMC produced a 637-cubic-inch (10.4 L) 60° V8 with a single camshaft using the same general layout (bore and stroke) as the 478 V6. The 637 V8 was the largest-displacement production gasoline V8 ...
GMC replaced the Pontiac 223 with their own 228-cubic-inch (3.7 L) 228 in 1939. This OHV (overhead valve) engine was produced through 1953. With a cylinder bore of 3.5625 inches (90.49 mm), this is the smallest low-deck engine. All four low-deck engines have a stroke of 3.8125 inches (96.84 mm) and used 7 inch long connecting rods.
The interchangeable parts include the rotating assembly (crank shaft, pistons, connecting rods, and flywheel/flex-plate) one piece rear main seal housing, oil pan and valve cover gaskets and valvetrain assembly (not including timing set, which includes a gear to drive the water pump). The LT1 uses a new engine block, cylinder head, timing cover ...
The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material changed to cast iron except in a few rare cases.