Ad
related to: valve steam engine
Search results
Results From The WOW.Com Content Network
Piston valves are one form of valve used to control the flow of steam within a steam engine or locomotive. They control the admission of steam into the cylinders and its subsequent exhausting, enabling a locomotive to move under its own power.
A Corliss steam engine – the valve gear is on the right of the cylinder block, on the left of the picture. A Corliss steam engine (or Corliss engine) is a steam engine, fitted with rotary valves and with variable valve timing patented in 1849, invented by and named after the US engineer George Henry Corliss of Providence, Rhode Island.
Collects steam at the top of the boiler (well above the water level) so that it can be fed to the engine via the main steam pipe, or dry pipe, and the regulator/throttle valve. [2] [5] [6]: 211–212 [3]: 26 Air pump / Air compressor Westinghouse pump (US+) Powered by steam, it compresses air for operating the train air brake system.
An expansion valve is a secondary valve within a steam engine. They represent an intermediate step between steam engines with non-expansive working and later valve gears that could provide for expansion by controlling the motion of a single valve. Expansion valves were used for stationary engines and marine engines. [1]
The Walschaerts valve gear on a steam locomotive (a PRR E6s).. The valve gear of a steam engine is the mechanism that operates the inlet and exhaust valves to admit steam into the cylinder and allow exhaust steam to escape, respectively, at the correct points in the cycle.
The Walschaerts valve gear is an improvement on the earlier Stephenson valve gear in that it enables the driver to operate the steam engine in a continuous range of settings from maximum economy to maximum power. At any setting, the valve gear satisfies the following two conditions:
Galloway uniflow steam engine, now in Thinktank, Birmingham Science Museum. Steam entry is usually controlled by poppet valves (which act similarly to those used in internal combustion engines) that are operated by a camshaft. The inlet valves open to admit steam when minimum expansion volume has been reached at the start of the stroke.
Cut-away drawing of steam engine speed governor. The valve starts fully open at zero speed, but as the balls rotate and rise, the central valve stem is forced downward and closes the valve. The drive shaft whose speed is being sensed is top right Porter governor on a Corliss steam engine. The devices shown are on steam engines.