Search results
Results From The WOW.Com Content Network
Within a few minutes, the thermistor should tell the compressor to start cooling. If it doesn't, you've most likely got a faulty thermistor. Photo: Westend61 / Getty Images
Common absorption refrigerators use a refrigerant with a very low boiling point (less than −18 °C (0 °F)) just like compressor refrigerators.Compression refrigerators typically use an HCFC or HFC, while absorption refrigerators typically use ammonia or water and need at least a second fluid able to absorb the coolant, the absorbent, respectively water (for ammonia) or brine (for water).
In the generator, on heat addition, the temperature increases, and with it, the partial pressure of the refrigerant vapor is released from the strong solution. However, the generator requires a heat source, which would consume energy unless waste heat is used. In an absorption refrigerator, a suitable combination of refrigerant and absorbent is ...
In 1911, GE released a household refrigeration unit that was powered by gas. The use of gas eliminated the need for an electric compressor motor and decreased the size of the refrigerator. However, electric companies that were customers of GE did not benefit from a gas-powered unit. Thus, GE invested in developing an electric model.
A defrost timer taken out of a household refrigerator. The defrost mechanism in a refrigerator heats the cooling element (evaporator coil) for a short period of time and melts the frost that has formed on it. [1] The resulting water drains through a duct at the back of the unit. Defrosting is controlled by an electric or electronic timer.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Amid growing anxieties surrounding reported drone sightings, the FBI has issued a warning against a new trend of pointing lasers at aircrafts.
An electric starter with sufficient power to turn a large diesel engine would itself be so large as to be impractical so there is a need for an alternative system. An air start system has three main components along with various safety components, namely the air start injector, the distributor and the air receivers.