Ads
related to: 1965 mustang performance suspension kits catalog free print
Search results
Results From The WOW.Com Content Network
Another of Fiberfab's early products was the E/T Mustang conversion. [21] This kit was designed by a moonlighting Larry Shinoda. [22] The final product looked somewhat like the nose of the mid-engined Ford Mustang I prototype. An estimated fifty E/T Mustang kits were produced by Fiberfab. One was installed on an original Shelby Mustang. [23]
The 1973 Ford Mustang was 8.5 inches (216 mm) longer, 5.9 inches (150 mm) wider, and over 600 lb (272 kg) heavier than the original 1965 Mustang. Big block V8 engines became available in pony cars, which increased straight-line performance but underscored the limitations of the suspension, brakes, and tires. The six-cylinder and lower ...
When equipped with the 289 "HiPo" engine and a 4.11 rear axle ratio, the 1965 Mustang achieved 0–60 mph (0–97 km/h) in 5.2 seconds and a 1 ⁄ 4 mile (402 m) time of 14.0 seconds at 100 mph (161 km/h). [34] The 1966 Mustang debuted with moderate trim changes including a new grille, side ornamentation, wheel covers, and gas cap.
From 1965 until 2004, the Mustang shared chassis commonality with other Ford model lines, staying rear-wheel-drive throughout its production. From 1965 to 1973, the Mustang was derived from the 1960 Ford Falcon compact. From 1974 until 1978, the Mustang (denoted Mustang II) was a longer-wheelbase version of the Ford Pinto.
The Shelby Mustang is a high-performance variant of the Ford Mustang built by Shelby American from 1965 to 1967 and by the Ford Motor Company from 1968 to 1970. In 2005, Ford revived the Shelby nameplate for a high-performance model of the fifth-generation Ford Mustang .
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!