When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Pfister (firm) - Wikipedia

   en.wikipedia.org/wiki/Pfister_(firm)

   Pfister, called Price Pfister until 2010, is an American manufacturer of bathroom and lavatory faucets, shower systems, showerheads and accessories, kitchen faucets and other plumbing fixtures. Emil Price and William Pfister founded the company in 1910.

3. Basin wrench - Wikipedia

   en.wikipedia.org/wiki/Basin_wrench

   A large basin wrench Large basin wrench, with jaws oriented to apply torque in counter-clockwise direction. A basin wrench, sometimes called a sink wrench, is a plumbing tool which is used in confined spaces to turn fasteners and pipes that would be difficult or impossible to reach with a plumber wrench or other types of wrenches. [1]

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Slip-joint fittings are frequently used in kitchen, bathroom and tub drainage systems. They include a detached (movable) slip nut and slip-joint washer; the washer is made of rubber or nylon. [ 17 ] An advantage of this type of fitting is that the pipe it is connecting to does not need to be cut to a precise length; the slip joint can attach ...

5. Low-flow fixtures - Wikipedia

   en.wikipedia.org/wiki/Low-flow_fixtures

   Faucets that meet energy efficiency standards for WaterSense mustn’t use more than 1.5 gpm, a 32% decrease in flow rate over the federal requirement. [10] Reduced flow faucets often make use of flow restrictors or faucet aerators to reduce the flowrate of the water. Using a faucet with an aerator results in an average 42% reduction in water ...

6. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   Faucet is the most common term in the US, similar in use to "tap" in British English, e.g. "water faucet" (although the term "tap" is also used in the US). Spigot is used by professionals in the trade (such as plumbers), and typically refers to an outdoor fixture.

7. Interference fit - Wikipedia

   en.wikipedia.org/wiki/Interference_fit

   As an example, a 10 mm (0.394 in) shaft made of 303 stainless steel will form a tight fit with allowance of 3–10 μm (0.00012–0.00039 in). A slip fit can be formed when the bore diameter is 12–20 μm (0.00047–0.00079 in) wider than the rod; or, if the rod is made 12–20 μm under the given bore diameter.