Search results
Results From The WOW.Com Content Network
A shunt resistor, which has been connected in parallel across the filament before it burnt out, will then short out to bypass the burnt filament and allow the rest of the string to light. If too many lights burn out however, a shunt will also burn out, requiring the use of a multimeter to find the point of failure.
An antifuse is an electrical device that performs the opposite function to a fuse.Whereas a fuse starts with a low resistance and is designed to permanently break or open an electrically conductive path (typically when the current through the path exceeds a specified limit), an antifuse starts with a high resistance—an open circuit—and programming it converts it into a permanent ...
Shunt resistor. The common and simple approach to current sensing is the use of a shunt resistor. That the voltage drop across the shunt is proportional to its current flow, i.e. ohm's law, makes the low resistance current shunt a very popular choice for current measurement system with its low cost and high reliability.
Some companies also offer software with which the street lights can be monitored and managed wirelessly. Clients, or other companies, can access the software from a computer, or even a tablet. From this software, they can gather data, pre-set levels of brightness and dimming time; receive warning signals when a light defects. [9] [10] [11] [12]
A number of street light control systems have been developed to control and reduce energy consumption of a town's public lighting system. These range from controlling a circuit of street lights and/or individual lights with specific ballasts and network operating protocols.
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
A basic double light colour light signal consists of two multiple lamp colour light signal heads, one above the other. In case of automatic signals, the upper and lower lights are vertically offset from each other or "staggered". Alternatively, the lower light may be directly below the upper light, like a controlled or semi-automatic signal.
In the US, street lights using sodium vapor were first installed on a rural highway near Port Jervis, New York, in 1933. [1] In 1938, a study of sodium vapor light use at selected intersections in Chicago claimed that the new lighting had helped to reduce the number of accidents in those areas.