Ads
related to: leupold scope mount height comparison calculator
Search results
Results From The WOW.Com Content Network
A Leupold telescopic sight mounted on a dovetailed rifle receiver via two scope rings From left: A sketch of a cross section on a Zeiss rail and ring mount, both with a Picatinny rail interface. Scope mounts are rigid implements used to attach (typically) a telescopic sight or other types of optical sights onto a firearm .
The scope base is the attachment interface on the rifle's receiver, onto which the scope rings or scope mount are fixed. Early telescopic sights almost all have the rings that are fastened directly into tapped screw holes on the receiver, hence having no additional scope base other than the receiver top itself.
Leupold and Stevens Mark 6 scope with variable magnification 3-18x44mm, mounted on a M24 SWS. IDF M24 SWS with Leupold Mark 6 3-18x44mm sniper scope. Leupold FX-II Ultralight scope on a Ruger 77/44. The company's riflescopes are used by organizations such as the United States Army, the Secret Service and the Navy SEALs. [13]
The approximate range of an object one foot (30.48 cm) in height covering roughly 100 milliradians is 10 feet (3.048 m) or: Range (r) = approximate height of object (h) × (1000 ÷ aperture in milliradians (a)) r = h(1000/a) → where r and h are identical units, and a is in milliradians.
The Weaver mount was developed by William Ralph Weaver (1905 – 8 November 1975) at his telescopic sight company W.R. Weaver Co., which he founded in 1930. [3] Previous systems included the Leupold/Redfield mounts. [4] Compared to the Leupold mount, the Weaver rail is not as strong and cannot be adjusted for windage. [4]
Scope: Leupold Ultra M3A 10×42mm fixed power, or Leupold Mk 4 LR/T M3 10×40mm fixed power scope. Detachable emergency Redfield-Palma International back-up iron sights, they are attached to iron sight bases that are screwed into drilled and tapped holes machined into the front of the barrel and back on the left side of the receiver. In 2001 ...
For this purpose scope mounts are sold with varying degrees of tilt, but some common values are: 3 mrad, which equals 3 m at 1000 m (or 0.3 m at 100 m) 6 mrad, which equals 6 m at 1000 m (or 0.6 m at 100 m) 9 mrad, which equals 9 m at 1000 m (or 0.9 m at 100 m) With a tilted mount the maximum usable scope elevation can be found by:
It is similar in concept to the earlier commercial Weaver rail mount used to mount telescopic sights, but is taller and has wider slots at regular intervals along the entire length. The MIL-STD-1913 locking slot width is 0.206 in (5.23 mm). The spacing of slot centres is 0.394 in (10.01 mm) and the slot depth is 0.118 in (3.00 mm). [8]