Ad
related to: converting measurements yards to feet
Search results
Results From The WOW.Com Content Network
And be it remembered that the iron yard of our Lord the King containeth 3 feet and no more, and a foot ought to contain 12 inches by the right measure of this yard measured, to wit, the 36th part of this yard rightly measured maketh 1 inch neither more nor less and 5 yards and a half make a perch that is 16 feet and a half measured by the ...
The measurement of altitude in international aviation (the flight level unit) is one of the few areas where the foot is used outside the English-speaking world. The most common plural of foot is feet. However, the singular form may be used like a plural when it is preceded by a number, as in "he is six foot tall." [8]
{{convert|123|cuyd|m3+board feet}} → 123 cubic yards (94 m 3; 40,000 board feet) The following converts a pressure to four output units. The precision is 1 (1 decimal place), and units are abbreviated and linked.
For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200 ⁄ 3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0.9144 ...
The basic unit of length in the imperial and U.S. customary systems is the yard, defined as exactly 0.9144 m by international treaty in 1959. [2] [5] Common imperial units and U.S. customary units of length include: [6] thou or mil (1 ⁄ 1000 of an inch) inch (25.4 mm) foot (12 inches, 0.3048 m) yard (3 feet, 0.9144 m)
Historically, a wide range of units was used for the same type of quantity. In different contexts length was measured in inches, feet, yards, fathoms, rods, chains, furlongs, miles, nautical miles, stadia, leagues, with conversion factors that were not based on power of ten.
The main units of length (inch, foot, yard and international mile) were the same in the US, though the US rarely uses some of the intermediate units today, such as the (surveyor's) chain (22 yards) and the furlong (220 yards). At one time, the definition of the nautical mile was based on the surface area of the Clarke ellipsoid.
Miners also use it as a unit of area equal to 6 feet square (3.34 m 2) in the plane of a vein. [2] In Britain, it can mean the quantity of wood in a pile of any length measuring 6 feet (1.8 m) square in cross section. [2] In Central Europe, the klafter was the corresponding unit of comparable length, as was the toise in France.