Ads
related to: rs232 check tester led driver install downloadwiki-drivers.com has been visited by 100K+ users in the past month
pchelpsoft.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
The ELM327 abstracts the low-level protocol and presents a simple interface that can be called via a UART, typically by a hand-held diagnostic tool or a computer program connected by USB, RS-232, Bluetooth or Wi-Fi. [2] New applications include smartphones. [3] There are a large number of programs available that connect to the ELM327. [4] [5]
Unlike GPIB, with the RS-232 interface, it is possible to connect and control only one device at a time. RS-232 is also a relatively slow interface with typical data rates of less than 20 KB/s. RS-232 is best suited for laboratory applications compatible with a slower, less rugged connection. It works on a ±24 volt supply.
While it was originally created for the IEEE-488.1 (GPIB) bus, [5] SCPI can also be used with RS-232, RS-422, RS-485, USB, Ethernet, VXIbus, HiSLIP, etc. [5] SCPI commands are ASCII textual strings, [5] which are sent to the instrument over the physical layer. [5] Commands are a series of one or more keywords, many of which take parameters.
The standard specifies a maximum open-circuit voltage of 25 volts: signal levels of ±5 V, ±10 V, ±12 V, and ±15 V are all commonly seen depending on the voltages available to the line driver circuit. Many RS-232 driver chips have inbuilt charge pump circuitry to produce the required voltages from a 3 or 5 volt supply. RS-232 drivers and ...
Frequent use of a serial port is for a direct computer-to-computer connection. This requires an adapter called a null modem, which isn't actually a modem in the traditional sense, but rather a connector plug that simply crosses the complementary pins on two serial ports so the two sides can communicate. A null modem typically connects the DTR ...
MAX232 chip in DIP-16 package The die of a MAX232 MAX232 pinout: Red: power, Yellow: charge pump capacitors, Blue: outputs, Green: inputs, Pins 9–12: TTL/CMOS I/O voltages. The MAX232 is an integrated circuit by Maxim Integrated Products, now a subsidiary of Analog Devices, that converts signals from a TIA-232 (RS-232) serial port to signals suitable for use in TTL-compatible digital logic ...
JTAG (named after the Joint Test Action Group which codified it) is an industry standard for verifying designs of and testing printed circuit boards after manufacture.. JTAG implements standards for on-chip instrumentation in electronic design automation (EDA) as a complementary tool to digital simulation. [1]
A test light, test lamp, voltage tester, or mains tester is a piece of electronic test equipment used to determine the presence of electricity in a piece of equipment under test. A test light is simpler and less costly than a measuring instrument such as a multimeter , and often suffices for checking for the presence of voltage on a conductor.