Search results
Results From The WOW.Com Content Network
Pressure in cylinder pattern in dependence on ignition timing: (a) - misfire, (b) too soon, (c) optimal, (d) too late. In a spark ignition internal combustion engine, ignition timing is the timing, relative to the current piston position and crankshaft angle, of the release of a spark in the combustion chamber near the end of the compression stroke.
The switch is automatically operated by a cam driven by the engine. The timing of operation of the switch is set so that a spark is produced at the right time to ignite the compressed air/fuel mixture in the cylinder of the engine. A mechanism may be provided to slightly adjust timing to allow for varying load on the engine.
A timing mark is an indicator used for setting the timing of the ignition system of an engine, typically found on the crankshaft pulley (as pictured) or the flywheel. [1] These have the largest radius rotating at crankshaft speed and therefore are the place where marks at one degree intervals will be farthest apart.
For this inline-4 engine, 1-3-4-2 could be a valid firing order.. The firing order of an internal combustion engine is the sequence of ignition for the cylinders.. In a spark ignition (e.g. gasoline/petrol) engine, the firing order corresponds to the order in which the spark plugs are operated.
A crank sensor (CKP) [1] [2] [3] is an electronic device used in an internal combustion engine, both petrol and diesel, to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control the fuel injection or the ignition system timing and other engine parameters
A variation coil-on-plug ignition has each coil handle two plugs, on cylinders which are 360 degrees out of phase (and therefore reach top dead center (TDC) at the same time); in the four-cycle engine this means that one plug will be sparking during the end of the exhaust stroke while the other fires at the usual time, a so-called "wasted spark ...
The Renix control system before 1991 can be tested only with Chrysler's DRB tester, and the diagnostic test modes for 1989 and later engines with SBEC controllers differ from those provided for 1988 and earlier models. [11] Model years: 1986 - Renix TBI became standard on Jeep 2.5 L AMC four-cylinder engines
In a reciprocating engine, top dead centre of piston #1 is the point from which ignition system measurements are made and the firing order is determined. For example, ignition timing is normally specified as degrees of crankshaft rotation before top dead centre (BTDC). [2]