Search results
Results From The WOW.Com Content Network
The commercially available B&W AC3-30 and B&W DS1.8-30 antennas [6] vary from the above to cover 3–30 MHz using a 90 foot length with an 18 inch spacing of the wires. The balun is a 16:1 ratio, thereby transforming the 50 Ω (ohm) coax to an 800 Ω feed at the antenna. The resistor load is also 800 Ω, non-inductive.
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
A 1 / 4 λ monopole antenna and its ground image together form a 1 / 2 λ dipole that radiates only in the upper half of space. The vertical , Marconi , or monopole antenna is a single-element antenna usually fed at the bottom (with the shield side of its unbalanced transmission line connected to ground).
G5RV Antenna without balun. The G5RV antenna is a dipole with a symmetric resonant [ 1 ] feeder line , which serves as impedance matcher for a 50 Ω coax cable to the transceiver . [ 2 ] [ 3 ]
Two element dipole array in front of a one wavelength square reflector used as gain standard The gain of practical array antennas is limited to about 25–30 dB. Two half wave elements spaced a half wave apart and a quarter wave from a reflecting screen have been used as a standard gain antenna with about 9.8 dBi at its design frequency. [ 4 ]
A halo antenna, or halo, is a center-fed 1 / 2 wavelength dipole antenna, which has been bent into a circle, with a break directly opposite the feed point. The dipole's ends are close, but do not touch, and the ends on either side of the gap may be flared out to form a larger air gap capacitor , whose spacing is used to fine-adjust the ...
The 1 / 2 λ dipole and the 1 / 2 λ folded dipole are commonly taken as having nominal impedances of 75 Ω and 300 Ω, respectively. [ 13 ] An installed antenna's feed-point impedance varies above and below the quoted value, depending on its installation height above the ground and the electrical properties of the surrounding ...
A turnstile antenna, or crossed-dipole antenna, [1] is a radio antenna consisting of a set of two identical dipole antennas mounted at right angles to each other and fed in phase quadrature; the two currents applied to the dipoles are 90° out of phase. [2] [3] The name reflects the notion the antenna looks like a turnstile when mounted ...