Search results
Results From The WOW.Com Content Network
In electrical engineering, an electrical isolation test is a direct current (DC) or alternating current (AC) resistance test that is performed on sub-systems of an electronic system to verify that a specified level of isolation resistance is met. Isolation testing may also be conducted between one or more electrical circuits of the same ...
Internal rotary inspection system (IRIS) is an ultrasonic method for the nondestructive testing of pipes and tubes. The IRIS probe is inserted into a tube that is flooded with water, and the probe is pulled out slowly as the data is displayed and recorded. The ultrasonic beam allows detection of metal loss from the inside and outside of the ...
A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [ 2 ] [ 3 ] A typical multimeter can measure voltage , resistance , and current , [ 4 ] in which case can be used as a voltmeter , ohmmeter , and ammeter .
PAT testing is not exclusively confined to formal testing but is rather a combination of inspection and testing processes. Most dangerous defects can be found simply by inspecting the appliances for obvious signs of damage such as frayed cables. According to the HSE, simple inspection can find more than 90% of defects. [7]
Visual inspection. A survey without touching anything, and looking at the electrical installation or product before starting any electrical testing. A visual inspection seeks to identify damaged insulation, disconnected wires, incorrect installation, and any other visual issues. Dead testing. Continuity test: a test to check the wiring is correct
An analog ohmmeter. An ohmmeter is an electrical instrument that measures electrical resistance (the opposition offered by a circuit or component to the flow of electric current). Multimeters also function as ohmmeters when in resistance-measuring mode. An ohmmeter applies current to the circuit or component whose resistance is to be measured.
Robotic non-destructive testing (NDT) is a method of inspection used to assess the structural integrity of petroleum, natural gas, and water installations. Crawler-based robotic tools are commonly used for in-line inspection (ILI) applications in pipelines that cannot be inspected using traditional intelligent pigging tools (or unpiggable pipelines).
Action describes energy summed up over the time a process lasts (time integral over energy). Its dimension is the same as that of an angular momentum.. A phototube provides a voltage measurement which permits the calculation of the quantized action (Planck constant) of light.