Search results
Results From The WOW.Com Content Network
The body of the magnetic drill holds together the motor and the magnet base. The feed handle is also attached to the body. The body of the magnetic drill helps the motor slide on it to get an upward and downward feed. The body of the magnetic drill also plays the role of a handle to lift and move the machine from one place to other.
An annular cutter (also called a core drill, core cutter, broach cutter, trepanning drill, hole saw, or cup-type cutter) is a form of core drill used to create holes in metal. An annular cutter, named after the annulus shape , cuts only a groove at the periphery of the hole and leaves a solid core or slug at the center.
A D-ring used to secure cargo in a utility trailer (A) D-ring (shown in isometric view) (B) Weld-on pivot link; note the incorrect fillet weld call-out (bottom-right). The correct method of securing a weld-on pivot link is a [t weld] which consists of a perpendicular vee butt joint secured to the billet using a butt weld or fusion weld.
Drilling is a cutting process where a drill bit is spun to cut a hole of circular cross-section in solid materials. The drill bit is usually a rotary cutting tool, often multi-point. The bit is pressed against the work-piece and rotated at rates from hundreds to thousands of revolutions per minute.
The planned difference between the drill diameter and the reamer diameter is called an allowance. (It allows for the removal of a certain small amount of material.) The allowance should be < 0.2 mm (.008 in) for soft materials and < 0.13 mm (.005 in) for hard materials. Larger allowances can damage the reamer.
The cutting ring fitting consists of the body, the cutting ring and the nut. On assembly, the two cutting edges of the cutting ring carves into the outer surface of the tube hence ensuring the necessary holding power and sealing for high operating pressures. [1] The tubes have usually metric dimensions.
The mentioned tool types differ with regard to the realizable diameter range, the achievable l/D ratios, the surface quality and their productivity. Symmetrical tools can only be used in the small diameter range of D = 0.2 ... 32 mm to produce holes with an l/D ratio up to a maximum of l/D = 85, the standard is an l/D ratio of l/D = 30.
Such a drill bit is called a reduced-shank or blacksmith's drill. For example, this allows a 1 ⁄ 2 -inch (13 mm) bit to be used in a pistol-grip drill's 3 ⁄ 8 -inch (9.5 mm) chuck. One particular type of reduced-shank drill bits are Silver & Deming ( S&D ) bits, whose sets run from 9 ⁄ 16 -inch (14 mm) to 1 + 1 ⁄ 2 -inch (38 mm) drill ...