Search results
Results From The WOW.Com Content Network
Circuit components of the external USB SuperDisk for Macintosh. The drive itself is the same size as a standard 3.5″ floppy drive, but uses an ATA interface. On the right is the USB-to-ATA adapter, which plugs into an intermediate fan-out and power supply daughterboard that is inside the rear of the Mac drive's casing.
In this final revision of the WPC hardware, the dot matrix controller and the DCS sound boards are combined into a single A/V board, while the Power/Driver and the Fliptronics boards are combined into a single Power/Driver board, bringing the board count down to three boards.
A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a combination. After IBM introduced the "twist" to floppy cables, and when both 5.25-inch and 3.5-inch drives were in common use, many cables had four connectors: one of each type before the twist, and one of each type after the twist.
A line driver is an electronic amplifier circuit designed for driving a load such as a transmission line. The amplifier's output impedance may be matched to the characteristic impedance of the transmission line. Line drivers are commonly used within digital systems, e.g. to communicate digital signals across circuit-board traces and cables. [1]
The second was Castlewood's own adapter "The ORB USB Smart Cable" Part Number 88205-001 (Male HD50 SCSI to USB). This single unit had two manually operated locking pins to keep it firmly connected. The attached USB cable had a clear transparent cover incorporating eight toroidal ceramic surge suppressing magnets close to the adapter.
The RAID 0 volume in Matrix RAID provides fast access to large files where data loss is not a critical issue but speed is; examples include video editing, swap files, and files that are backed up. Intel Matrix RAID, Intel Rapid RAID, and Intel Smart Response Technology are together described as Intel Rapid Storage Technology. [9]
High voltage is defined as any voltage over 1000 volts. [3] Those of 2 to 33 kV are usually called medium voltage cables, those over 50 kV high voltage cables.. Modern HV cables have a simple design consisting of a few parts: the conductor, the conductor shield, the insulation, the insulation shield, the metallic shield, and the jacket.
The change prevents the chip from being recognised by drivers of any OS, effectively making them inoperable unless the product ID is changed back. [14] The behaviour was supported by a notice in the drivers' end user license agreement, which warned that use of the drivers with non-genuine FTDI products would "irretrievably damage" them. [14]