When.com Web Search

  1. Ads

    related to: coaxial cable splitting frequency range table for tv
    • Network Cables

      Custom Lengths and Colors

      In Stock. Same Day Shipping!

    • USB Cables

      USB 2.0, Printer Cables, Micro USB

      High Quality USB Cables & Devices.

Search results

  1. Results From The WOW.Com Content Network
  2. Coaxial cable - Wikipedia

    en.wikipedia.org/wiki/Coaxial_cable

    Assuming the dielectric properties of the material inside the cable do not vary appreciably over the operating range of the cable, the characteristic impedance is frequency independent above about five times the shield cutoff frequency. For typical coaxial cables, the shield cutoff frequency is 600 Hz (for RG-6A) to 2,000 Hz (for RG-58C). [10]

  3. Single-cable distribution - Wikipedia

    en.wikipedia.org/wiki/Single-cable_distribution

    Special LNBs have been developed for use in single-cable distribution systems. All four sub-bands of the Ku band (low frequency/horizontal polarity, high frequency/horizontal polarity, low frequency/vertical polarity, high frequency/vertical polarity) are received by a conventional front end, amplified and downconverted to the L-band, to be fed to a number of SatCR (Satellite Channel Router ...

  4. DOCSIS - Wikipedia

    en.wikipedia.org/wiki/DOCSIS

    A mid-split increases the upstream frequency range to 5–85 MHz, supporting a total shared upstream capacity of ~450 Mbit/s (assuming 4 SC-QAM + OFDMA channels) for the service group. [ 26 ] A high-split increases the upstream frequency range to 5–204 MHz, supporting a total shared upstream capacity of ~1.5 Gbit/s (assuming 4 SC-QAM + OFDMA ...

  5. Hybrid fiber-coaxial - Wikipedia

    en.wikipedia.org/wiki/Hybrid_fiber-coaxial

    Trunk coaxial cables are connected to the optical node [34] [35] and form a coaxial backbone to which smaller distribution cables connect. RF amplifiers called trunk amplifiers are used at intervals in the trunk to overcome cable attenuation and passive losses of the electrical signals caused by splitting or "tapping" the coaxial cable. Trunk ...

  6. Frequency-division multiplexing - Wikipedia

    en.wikipedia.org/wiki/Frequency-division...

    For example, the coaxial cable used by cable television systems has a bandwidth of about 1000 MHz, but the passband of each television channel is only 6 MHz wide, so there is room for many channels on the cable (in modern digital cable systems each channel in turn is subdivided into subchannels and can carry up to 10 digital television channels).

  7. Cable television - Wikipedia

    en.wikipedia.org/wiki/Cable_television

    A coaxial cable used to carry cable television onto subscribers' premises A set-top box, an electronic device which cable subscribers use to connect the cable signal to their television sets. Presented unit is a Cisco RNG200N for QAM digital cable television system used in North America.