Ads
related to: how to boost mic gain time
Search results
Results From The WOW.Com Content Network
This means that (1) moving the microphone closer to the sound source increases the signal level produced by the microphone, and (2) moving the microphone further away from undesirable noise sources will diminish the amount of noise in the microphone signal. Microphone placement is therefore an important aspect of gain staging [citation needed].
In both fields the amount of gain is measured in decibels at or just below the point at which the sound from the speaker driver re-enters the microphone and the system begins to ring or feed back. Potential acoustic gain (PAG) is a calculated figure representing gain that a system can support without feeding back. [1]
Here, the still-mic-level signal enters into a microphone preamplifier, which boosts the signal voltage to line level. For this example, the microphone preamplifier is built into a mixing board. It is typical for a mixing board to include a line trim after the preamplifier. This allows the amplitude of the now line-level signal to be adjusted.
Audio feedback from microphones occurs when a microphone is too near a monitor or main speaker and the sound reinforcement system amplifies itself. Audio feedback through a microphone is almost universally regarded as a negative phenomenon, many electric guitarists use guitar feedback as part of their performance. This type of feedback is ...
Automixers balance multiple sound sources based on each source's level, quickly and dramatically adjusting the various signal levels automatically. [2] Automixers are used in live sound reinforcement to maintain a steady limit on the overall signal level of the microphones; if a public address system is set up so that one microphone will not feed back, then, in general, the automixer will ...
Schematic of an AGC used in the analog telephone network; the feedback from output level to gain is effected via a Vactrol resistive opto-isolator.. Automatic gain control (AGC) is a closed-loop feedback regulating circuit in an amplifier or chain of amplifiers, the purpose of which is to maintain a suitable signal amplitude at its output, despite variation of the signal amplitude at the input.
The equipment for the techniques also varies from the bulky to the small and convenient. A-B techniques generally use two separate microphone units, often mounted on a bar to define the separation. X-Y microphone capsules can be mounted in one unit, or even on the top of a handheld digital recorder.
Voltage vs. time of sine waves at reference and line levels, with V RMS, V PK, and V PP marked for the +4dBu line level. A line level describes a line's nominal signal level as a ratio, expressed in decibels, against a standard reference voltage. The nominal level and the reference voltage against which it is expressed depend on the line level ...