Ads
related to: mortise door knobs and backplates outdoor kitchen island with sink
Search results
Results From The WOW.Com Content Network
The parts included in the typical US mortise lock installation are the lock body (the part installed inside the mortise cut-out in the door); the lock trim (which may be selected from any number of designs of doorknobs, levers, handle sets and pulls); a strike plate (or box keep), which lines and reinforces the cavity in the door jamb or frame ...
A mortise is a hole cut into a timber to receive a tenon. There are several kinds of mortise: [16] Open mortise: a mortise that has only three sides. (See bridle joint). Stub mortise: a shallow mortise, the depth of which depends on the size of the timber; also a mortise that does not go through the workpiece (as opposed to a "through mortise").
The first known example of a tumbler lock was found in the ruins of the Palace of Khorsabad built by king Sargon II (721–705 BC.) in Iraq. [1] Basic principles of the pin tumbler lock may date as far back as 2000 BC in Egypt; the lock consisted of a wooden post affixed to the door and a horizontal bolt that slid into the post.
Leonardo da Vinci's early 16th century painting, Mona Lisa, is featured as a major plot point in the film.. During the COVID-19 pandemic in May 2020, Miles Bron, the co-founder of technology company Alpha, hosts a murder mystery game at the Glass Onion, his mansion on a private island in Greece.
An unusual barn in Schoonebeek, Netherlands, with interrupted sills; the posts land directly on the padstone foundation Norwegian style framing, Kravik Mellom, Norway. In historic buildings the sills were almost always large, solid timbers framed together at the corners, carry the bents, and are set on the stone or brick foundation walls, piers, or piles (wood posts driven or set into the ground).
Side and end view of a 4-fluted countersink. The fluted countersink cutter is used to provide a heavy chamfer in the entrance to a drilled hole. This may be required to allow the correct seating for a countersunk-head screw or to provide the lead in for a second machining operation such as tapping.