When.com Web Search

  1. Ads

    related to: water pressure tester gauge

Search results

  1. Results From The WOW.Com Content Network
  2. Hydrostatic test - Wikipedia

    en.wikipedia.org/wiki/Hydrostatic_test

    The test involves filling the vessel or pipe system with a liquid, usually water, which may be dyed to aid in visual leak detection, and pressurization of the vessel to the specified test pressure. Pressure tightness can be tested by shutting off the supply valve and observing whether there is a pressure loss.

  3. Pressure measurement - Wikipedia

    en.wikipedia.org/wiki/Pressure_measurement

    Gauge pressure is zero-referenced against ambient air pressure, so it is equal to absolute pressure minus atmospheric pressure. A tire pressure gauge is an example of gauge pressure measurement; when it indicates zero, then the pressure it is measuring is the same as the ambient pressure.

  4. Mercury pressure gauge - Wikipedia

    en.wikipedia.org/wiki/Mercury_pressure_gauge

    The parent of all mercury pressure gauges is the mercury barometer invented by Evangelista Torricelli in 1643. [15] An early engineering application of the mercury pressure gauge was to measure pressure in steam boilers during the age of steam. The first use on steam engines was by James Watt while developing the Watt steam engine between 1763 ...

  5. Inch of water - Wikipedia

    en.wikipedia.org/wiki/Inch_of_water

    It is defined as the pressure exerted by a column of water of 1 inch in height at defined conditions. At a temperature of 4 °C (39.2 °F) pure water has its highest density (1000 kg/m 3). At that temperature and assuming the standard acceleration of gravity, 1 inAq is approximately 249.082 pascals (0.0361263 psi). [2]

  6. Water flow test - Wikipedia

    en.wikipedia.org/wiki/Water_flow_test

    First, a static pressure gauge is attached to the test hydrant and the static water pressure is measured at the test hydrant. Second, the flow hydrant opened to allow water to flow in a fully open condition. Simultaneously the pitot tube pressure is recorded from the flow hydrant while the residual pressure is measured from the test hydrant.

  7. Deadweight tester - Wikipedia

    en.wikipedia.org/wiki/Deadweight_tester

    A dead weight tester (DWT) is a calibration standard method that uses a piston cylinder on which a load is placed to make an equilibrium with an applied pressure underneath the piston. Deadweight testers are secondary standards which means that the pressure measured by a deadweight tester is defined through other quantities: length, mass and time.

  1. Ads

    related to: water pressure tester gauge