Search results
Results From The WOW.Com Content Network
Cast bullets as cast (left), with gas check (center) and lubricated (right). A gas check is a gasket type component of firearms ammunition. Gas checks are used when non-jacketed bullets are used in high pressure cartridges. The use of a gas check inhibits the buildup of lead in the barrel and improves accuracy. [1]
The other used on gas operated firearms, usually a small hole on the barrel/gas block that is used to push back a gas piston to unlock the bolt. Gas check: A device used in some types of firearms ammunition when non-jacketed bullets are used in high pressure cartridges, to prevent the buildup of lead in the barrel and aid in accuracy. [17] Gas ...
Lead could be cast in a ladle over a wood fire used for cooking or home heating, while casting iron required higher temperatures. Greater density of lead allowed lead bullets to retain velocity and energy better than iron bullets of the same weight and initial firing velocity. [2] Minié balls of the mid-19th century could be either cast or swaged.
This worked well for low-speed bullets, fired at velocities of less than 450 m/s (1,475 ft/s). For slightly higher-speed bullets fired in modern firearms, a harder alloy of lead and tin or typesetter's lead (used to mold linotype) works very well. For even higher-speed bullet use, jacketed lead bullets are used.
In firearms, a blowback system is generally defined as an operating system in which energy to operate the firearm's various mechanisms, and automate the loading of another cartridge, is derived from the inertia of the spent cartridge case being pushed out the rear of the chamber by rapidly expanding gases produced by a burning propellant, typically gunpowder. [3]
short-stroke gas piston Short stroke gas piston and bolt carrier group, from a gas piston AR-15. With a short-stroke or tappet system, the piston moves separately from the bolt group. It may directly push [12] the bolt group parts, as in the M1 carbine, or operate through a connecting rod or assembly, as in the Armalite AR-18 or the SKS.
The final result is a barrel that is mirror-smooth, and with a consistent or slightly tapering bore. The hand-lapping technique uses a wooden or soft metal rod to pull or push the slug through the bore, while the newer fire-lapping technique uses specially loaded, low-power cartridges to push abrasive-covered soft-lead bullets down the barrel.
12-inch (30 cm) automatic gas-check. Attached to the base of RML artillery shells from 1878 onwards to avoid gas wastage on firing, and to rotate studless shells. It was an interim measure between studs and modern driving bands. Related terms: "Attached gas-check" – used with studded ammunition "Automatic gas-check" – used with studless ...