When.com Web Search

  1. Ads

    related to: sprinkler head pressure chart for winter

Search results

  1. Results From The WOW.Com Content Network
  2. Matched precipitation rate - Wikipedia

    en.wikipedia.org/wiki/Matched_precipitation_rate

    In order to be "matched" all sprinkler heads in a given zone must have the same rate of precipitation. This can be achieved by matching the gallonage of a standard rotor to its arc and reducing range accordingly (i.e. 2 gallons at 90 degrees, 4 gallons at 180 degrees, or 8 gallons if the head does a full circle) or by using MPR nozzles or ...

  3. K-factor (fire protection) - Wikipedia

    en.wikipedia.org/wiki/K-factor_(fire_protection)

    Using metric units, the volumetric flow rate of a nozzle is given by =, [1] [2] where q is the flow rate in litres per minute ( l/min ), p is the pressure at the nozzle in bar and K is the K-factor is given in units of (/) /.

  4. Fire sprinkler system - Wikipedia

    en.wikipedia.org/wiki/Fire_sprinkler_system

    A fire sprinkler system is an active fire protection method, consisting of a water supply system providing adequate pressure and flowrate to a water distribution piping system, to which fire sprinklers are connected. Although initially used only in factories and large commercial buildings, systems for homes and small buildings are now available ...

  5. Fire sprinkler - Wikipedia

    en.wikipedia.org/wiki/Fire_sprinkler

    A fire sprinkler mounted on a ceiling. A fire sprinkler or sprinkler head is the component of a fire sprinkler system that discharges water when the effects of a fire have been detected, such as when a predetermined temperature has been exceeded. Fire sprinklers are extensively used worldwide, with over 40 million sprinkler heads fitted each year.

  6. Hydraulic calculation - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_calculation

    The branch lines may terminate in a dead end or may connect at each end to different (usually opposite) points on the looped main. In the latter case, less water supply pressure is required as the hydraulic pressure drop is lower in the branch pipe as water flows from both ends of the branch line to any sprinkler.

  7. Irrigation - Wikipedia

    en.wikipedia.org/wiki/Irrigation

    Newer systems have drop sprinkler heads as shown in the image that follows. As of 2017 most center pivot systems have drops hanging from a U-shaped pipe attached at the top of the pipe with sprinkler heads that are positioned a few feet (at most) above the crop, thus limiting evaporative losses. Drops can also be used with drag hoses or ...