Ads
related to: how to check furnace ignitor
Search results
Results From The WOW.Com Content Network
Simply push down on the ignition button to allow gas to flow to the pilot light, before lighting the pilot light with the lighter or lit match, then release the ignition button.
As batteries became more common in cars (due to the increased usage of electric starter motors), magneto systems were replaced by systems using an induction coil.The 1886 Benz Patent-Motorwagen and the 1908 Ford Model T used a trembler coil ignition system, whereby the trembler interrupted the current through the coil and caused a rapid series of sparks during each firing.
In natural gas furnaces, water heaters, and room heating systems, a safety cut-off switch is normally included so that the gas supply to the pilot and heating system is shut off by an electrically operated valve if the pilot light goes out. This cut-off switch usually detects the pilot light in one of several ways:
Heat ignitor or start spark-ignition system; Open gas valve to ignite main burners; Wait (if furnace is relatively recent) until the heat exchanger is at proper operating temperature before starting main blower fan or circulator pump; Oil Similar to gas, except rather than opening a valve, the furnace will start an oil pump to inject oil into ...
Loss on ignition (LOI) is a test used in inorganic analytical chemistry and soil science, particularly in the analysis of minerals and the chemical makeup of soil. It consists of strongly heating ( "igniting" ) a sample of the material at a specified temperature, allowing volatile substances to escape, until its mass ceases to change.
A flame detector is a sensor designed to detect and respond to the presence of a flame or fire, allowing flame detection.Responses to a detected flame depend on the installation, but can include sounding an alarm, deactivating a fuel line (such as a propane or a natural gas line), and activating a fire suppression system.