Search results
Results From The WOW.Com Content Network
Destination unreachable is generated by the host or its inbound gateway [2] to inform the client that the destination is unreachable for some reason. Reasons for this message may include: the physical connection to the host does not exist (distance is infinite); the indicated protocol or port is not active; the data must be fragmented but the ...
MTR also has a User Datagram Protocol (UDP) mode (invoked with "-u" on the command line or pressing the "u" key in the curses interface) that sends UDP packets, with the time to live (TTL) field in the IP header increasing by one for each probe sent, toward the destination host. When the UDP mode is used, MTR relies on ICMP port unreachable ...
Ping measures the round-trip time for messages sent from the originating host to a destination computer that are echoed back to the source. The name comes from active sonar terminology that sends a pulse of sound and listens for the echo to detect objects under water. [1] Ping operates by means of Internet Control Message Protocol (ICMP) packets.
The request has been fulfilled, resulting in the creation of a new resource. [6] 202 Accepted The request has been accepted for processing, but the processing has not been completed. The request might or might not be eventually acted upon, and may be disallowed when processing occurs. 203 Non-Authoritative Information (since HTTP/1.1)
ICMPv6 provides a minimal level of message integrity verification by the inclusion of a 16-bit checksum in its header. The checksum is calculated starting with a pseudo-header of IPv6 header fields according to the IPv6 standard, [6] which consists of the source and destination addresses, the packet length and the next header field, the latter of which is set to the value 58.
The simplest approach uses ICMP ECHO REQUEST messages to an unallocated IP address, such as 1.2.3.4. Since 1.2.3.4 is not allocated, the ICMP REQUEST will not be routed by routers without a default route; ICMP DESTINATION UNREACHABLE messages that may be created by those routers can just be ignored by the server.
RTT is a measure of the amount of time taken for an entire message to be sent to a destination and for a reply to be sent back to the sender. The time to send the message to the destination in its entirety is known as the network latency, and thus RTT is twice the latency in the network plus a processing delay at the destination. The other ...
The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination. The sum of the mean times in each hop is a measure of the total time spent to establish the connection. The command aborts if all (usually three) sent packets are lost more than twice.