Ads
related to: kumkum powder vs sindoor good quality tape
Search results
Results From The WOW.Com Content Network
Kumkum powder from Mysore, India. Kumkuma is a powder used for social and religious markings in India.It is made from turmeric or any other local materials. The turmeric is dried and powdered with a bit of slaked lime, which turns the rich yellow powder into a red color.
The higher the dynamic range of music, the more demanding it is of tape quality; alternatively, heavily compressed music sources can do well even with basic, inexpensive tapes. [8] Sensitivity of the tape, referred to that of an IEC reference tape and expressed in dB, was usually measured at 315 Hz and 10 kHz. [19] Stability of playback in time.
The turmeric powder becomes red when mixed with lime juice or lime powder. [5] Unlike red lead and vermilion, these are not poisonous. [ 5 ] [ 6 ] Modern material being sold as sindoor mainly uses vermilion, an orange-red pigment, the purified and powdered form of cinnabar , which is the chief form in which mercury sulfide naturally occurs.
Cassette tape, a two-spool tape cassette format for analog audio recording and playback and introduced in 1963 by Philips; DC-International, a format that was created by Grundig after Phillips had abandoned an earlier format that was being created alongside the Compact Cassette; 8-track tape, continuous loop tape system introduced in 1964
A traditional bindi is red or maroon in colour. A pinch of vermilion powder is applied with a ring-finger to make a dot. A small annular disc aids application for beginners. First, a sticky wax paste is applied through the empty centre of the disc. This is then covered with kumkum or vermilion and then the disc is removed to get a round bindi.
Sindoor is a vermilion-colored powder with which Hindu women make a mark in their hairline to indicate they are married. The Shaolin temple, where Buddhist monk Bodhidharma is reputed to have established the new sect of Chan Buddhism (Zen Buddhism), is colored a bright tone of vermilion.
The starting point for the tape casting process is the powder that the 'tape' is to be consisting of. This is the active component of the final product and the other contents, such as binder material and solvents have to be compatible with the powder. The powder is in general very fine, with maximum particle sizes of 5 micrometers. [8]
The first commonly available increase in tape length resulted from a reduction in backing thickness from 1.5 to 1.0 mil (38 to 25 μm) resulting in a total thickness reduction from 42 to 35 μm (1.7 to 1.4 mils), which allowed 3,600 ft (1,100 m), 1,800 ft (550 m), and 900 ft (270 m) tapes to fit on ten-and-a-half-, seven-, and five-inch reels respectively.