When.com Web Search

  1. Ads

    related to: doo bluh double track hitch replacement

Search results

  1. Results From The WOW.Com Content Network
  2. Round turn and two half-hitches - Wikipedia

    en.wikipedia.org/.../Round_turn_and_two_half-hitches

    Variations of this hitch can be made with differing numbers of turns and half-hitches; an example is illustrated below. With additional turns, it becomes a pipe hitch. The Round Turn and Two Half Hitches is named by Steel in 1794. If a spar is small, a round turn is preferable to a single turn. It makes a stronger knot and dissipates the wear.

  3. Taut-line hitch - Wikipedia

    en.wikipedia.org/wiki/Taut-line_hitch

    One taut-line hitch is tied 15–30 cm from the aircraft and adjusted for tension, then a second taut-line hitch is tied 5–20 cm further from the aircraft and finished with a half-hitch. Wind-induced lift tends to pull the knot tighter, gust-induced oscillations tend to damp-out, and once the half hitch is undone, pushing the lower working ...

  4. Two half-hitches - Wikipedia

    en.wikipedia.org/wiki/Two_half-hitches

    Two half hitches is the commonest of all hitches for mooring in particular and also for general utility. Steel gives the name in 1794. The difference between two half hitches and the clove hitch is that the former, after a single turn around a spar, is made fast around its own standing part, while the latter is tied directly around the spar.

  5. Rolling hitch - Wikipedia

    en.wikipedia.org/wiki/Rolling_hitch

    The Ashley Book of Knots identifies these two variations as "Rolling Hitch (1)" and "Rolling Hitch (2)" and numbers them #1734 and #1735 respectively. Despite the potential for confusion with the older usage, Ashley chose the name "Magnus Hitch" to refer to knot #1736, which is simply #1734 tied with the final hitch made in the opposite ...

  6. Clove hitch - Wikipedia

    en.wikipedia.org/wiki/Clove_hitch

    The clove hitch is an ancient type of knot, made of two successive single hitches [1]: 283 tied around an object. It is most effectively used to secure a middle section of rope to an object it crosses over, [ 1 ] : 213 such as a line on a fencepost.

  7. Diamond hitch - Wikipedia

    en.wikipedia.org/wiki/Diamond_hitch

    The steps used to tie a diamond hitch with six points of anchorage. In the diagram shown to the left, six points are used, but the top left, right, bottom left and right points can be ignored by simply "tucking" the rope beneath the load to be tied down, provided its shape and size allow, as is the case when the knot is used on a pack-saddle where those four extra points are simply the four ...