Search results
Results From The WOW.Com Content Network
One langmuir corresponds to an exposure of 10 −6 Torr during one second. [1] [2] For example, exposing a surface to a gas pressure of 10 −8 Torr for 100 seconds corresponds to 1 L. Similarly, keeping the pressure of oxygen gas at 2.5·10 −6 Torr for 40 seconds will give a dose of 100 L.
The torr is defined as 1 / 760 of one standard atmosphere, while the atmosphere is defined as 101325 pascals. Therefore, 1 Torr is equal to 101325 / 760 Pa. The decimal form of this fraction ( 133.322 368 421 052 631 578 947 ) is an infinitely long, periodically repeating decimal ( repetend length: 18).
Ultra-high vacuum (often spelled ultrahigh in American English, UHV) is the vacuum regime characterised by pressures lower than about 1 × 10 −6 pascals (1.0 × 10 −8 mbar; 7.5 × 10 −9 Torr). UHV conditions are created by pumping the gas out of a UHV chamber.
The laws describing the behaviour of gases under fixed pressure, volume, amount of gas, and absolute temperature conditions are called gas laws.The basic gas laws were discovered by the end of the 18th century when scientists found out that relationships between pressure, volume and temperature of a sample of gas could be obtained which would hold to approximation for all gases.
New Jersey Air Pollution Control Law consists of legislative and regulatory measures intended to limit the amount of harmful substances found in the air. In New Jersey, the federal Clean Air Act and the state Air Pollution Control Act (1954) are the most significant pieces of air pollution control legislation. These laws are implemented and ...
Accidental release source terms are the mathematical equations that quantify the flow rate at which accidental releases of liquid or gaseous pollutants into the ambient environment which can occur at industrial facilities such as petroleum refineries, petrochemical plants, natural gas processing plants, oil and gas transportation pipelines, chemical plants, and many other industrial activities.
The table below displays densities and specific volumes for various common substances that may be useful. The values were recorded at standard temperature and pressure, which is defined as air at 0 °C (273.15 K, 32 °F) and 1 atm (101.325 kN/m 2, 101.325 kPa, 14.7 psia, 0 psig, 30 in Hg, 760 torr). [4]
The affinity laws are useful as they allow the prediction of the head discharge characteristic of a pump or fan from a known characteristic measured at a different speed or impeller diameter. The only requirement is that the two pumps or fans are dynamically similar, that is, the ratios of the fluid forced are the same.