Search results
Results From The WOW.Com Content Network
TRW Inc. was an American corporation involved in a variety of businesses, mainly aerospace, electronics, automotive, and credit reporting. [2] It was a pioneer in multiple fields including electronic components, integrated circuits, computers, software and systems engineering .
They had good success with their early switching locomotives, [14] but the 38D 8-1/8 experienced problems in mainline service that were not encountered in naval service. As originally configured for the Erie-Built locomotives of 1945, the engine ran at a Brake Mean Effective Pressure of 95.2 psi, as opposed to the 85 psi rating for Navy engines ...
Note that for the automotive/hotrod use-case the most convenient (used by enthusiasts) unit of length for the piston-rod-crank geometry is the inch, with typical dimensions being 6" (inch) rod length and 2" (inch) crank radius. This article uses units of inch (") for position, velocity and acceleration, as shown in the graphs above.
TRW Automotive was an American company based in Livonia, Michigan.Tracing its roots from TRW Inc., [2] [3] TRW Automotive's production featured a variety of automotive products including integrated vehicle control and driver assist systems, braking systems, steering systems, suspension systems, seat belts and airbags, and engine valves among others. [4]
Depending on the model the displacement was 2.1 L (2,127 cc) (as B21), 2.3 L (2,316 cc) (same as B23/B230 automotive) or 2.5 L (2,490 cc). The engines with 2.5 L (2,490 cc) displacement, identified as the Volvo Penta AQ151 (8 valve) and AQ171 (dohc 16 valve) models, got a forged crankshaft with a longer stroke of 86 mm (3.39 in) together with ...
In some older engines (such as the Chevrolet Gen-2 "Stovebolt" inline-six, the GMC straight-6 engine, the Buick Straight-eight, and the Chrysler "Slant 6") the bore pitch is additionally extended to allow more material between the main bearing webs in the block. For example, in an L6 the first pair (#1 & 2), center pair (#3 & 4), and rear pair ...
Main page; Contents; Current events; Random article; About Wikipedia; Contact us
A crosshead as part of a reciprocating piston and slider-crank linkage mechanism. Cylindrical trunk guide Hudswell Clarke Nunlow; crosshead and two slide bars. In mechanical engineering, a crosshead [1] is a mechanical joint used as part of the slider-crank linkages of long stroke reciprocating engines (either internal combustion or steam) and reciprocating compressors [2] to eliminate ...