Search results
Results From The WOW.Com Content Network
The hot crude oil is then passed into a distillation column that allows the separation of the crude oil into different fractions depending on the difference in volatility. The pressure at the top is maintained at 1.2–1.5 atm [ 2 ] so that the distillation can be carried out at close to atmospheric pressure, and therefore it is known as the ...
Below is a schematic flow diagram of a typical crude oil distillation unit. The incoming crude oil is preheated by exchanging heat with some of the hot, distilled fractions and other streams. It is then desalted to remove inorganic salts (primarily sodium chloride). Following the desalter, the crude oil is further heated by exchanging heat with ...
The crude oil is fed to a stabilizer which is typically a tray or packed tower column that achieves a partial fractionation or distillation of the oil. [4] The heavier components, pentane (C 5 H 12 ), hexane (C 6 H 14 ), and higher hydrocarbons (C 7 +), flow as liquid down through the column where the temperature is increasingly higher.
[1] [2] [41] Below is a schematic flow diagram of a typical crude oil distillation unit. The incoming crude oil is preheated by exchanging heat with some of the hot, distilled fractions and other streams. It is then desalted to remove inorganic salts (primarily sodium chloride). Following the desalter, the crude oil is further heated by ...
Catalytic reforming is a chemical process used to convert naphthas from crude oil into liquid products called reformates, which are premium "blending stocks" for high-octane gasoline. The process converts low-octane linear hydrocarbons (paraffins) into branched alkanes (isoparaffins) and cyclic naphthenes , which are then partially ...
The feedstock to the FCC conversion process usually is heavy gas oil (HGO), which is that portion of the petroleum (crude oil) that has an initial boiling-point temperature of 340 °C (644 °F) or higher, at atmospheric pressure, and that has an average molecular weight that ranges from about 200 to 600 or higher; heavy gas oil also is known as ...
While not used as commonly as other techniques today, distillation is used in the process of refining petroleum. It involves the dividation of the crude oil into hydrocarbon categories, and products are recovered from the heated material. [17] A distillation tower is used in separation of the oil, with anywhere between 2 and 300 theoretical plates.
Vacuum distillation can also be referred to as "low-temperature distillation". [citation needed] In distilling the crude oil, it is important not to subject the crude oil to temperatures above 370 to 380 °C because high molecular weight components in the crude oil will undergo thermal cracking and form petroleum coke at