Ad
related to: hardware ports on my computer are connected to one side
Search results
Results From The WOW.Com Content Network
Examples of computer connector sockets on various laptops Ports on the back of the Apple Mac Mini (2005) A computer port is a hardware piece on a computer where an electrical connector can be plugged to link the device to external devices, such as another computer, a peripheral device or network equipment. [1] This is a non-standard term.
The IRQ lines are typically configurable in the hardware as well. Assigning the same interrupt to more than one printer port should be avoided and will typically cause one of the corresponding ports to work in polled mode only. The port addresses assigned to slot can be determined by reading the BIOS Data Area (BDA) at 0000h:0408h.
The earliest hard disk drive (HDD) interfaces were bit serial data interfaces that connected an HDD to a controller with two cables, one for control and one for data. [a] An additional cable was used for power, initially frequently AC but later usually connected directly to a DC power supply unit. The controller provided significant functions ...
COM port (DE-9 connector). COM (communication port) [1] [2] is the original, yet still common, name of the serial port interface on PC-compatible computers. It can refer not only to physical ports, but also to emulated ports, such as ports created by Bluetooth or USB adapters.
An IEEE 1284 36-pin male micro ribbon printer cable connection. The computer side normally uses a DB-25 port instead of this connector. IEEE 1284, also known as the Centronics port, is a standard that defines bi-directional parallel communications between computers and other devices.
Thunderbolt is the brand name of a hardware interface for the connection of external peripherals to a computer.It was developed by Intel in collaboration with Apple. [7] [8] It was initially marketed under the name Light Peak, and first sold as part of an end-user product on 24 February 2011.
To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...
As the port is designed to work with both SATA and USB, both organizations have formally approved it. The USB Implementers Forum states it does not support any connector used by other standards, hence such 'combo' ports are to be used at one's own risk.