When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Injector pen - Wikipedia

   en.wikipedia.org/wiki/Injector_pen

   [2] [7] Today, pen needles are manufactured at shorter needle lengths than required for typical vial and syringe administration, which decreases the pain associated with injection. [2] They are available in multiple lengths and gauge of needle, including 3.5mm, 4mm, 5mm, and 8mm lengths, and 31 through 34 gauge. [8]

3. Birmingham gauge - Wikipedia

   en.wikipedia.org/wiki/Birmingham_gauge

   The Birmingham gauge ranges from 5/0 or 00000, the lowest gauge number corresponding to the largest size of 0.500 inches (12.7 mm), to 36, the highest gauge number corresponding to the smallest size of 0.004 inches (0.10 mm).

4. Microneedles - Wikipedia

   en.wikipedia.org/wiki/Microneedles

   Dermarollers are hand-held rollers equipped with a total of 192 solid steel micro-sized needles arranged into 24 arrays, lengths ranging from 0.5-1.5mm. [ 31 ] [ 33 ] With the growing popularity of microneedling, MNs have also been commodified into home care Dermarollers, which are similar to medical dermarollers, except that the needles are ...

5. Hypodermic needle - Wikipedia

   en.wikipedia.org/wiki/Hypodermic_needle

   By 2008, all-plastic needles were in production and in limited use. One version was made of Vectra (plastic) aromatic liquid crystal polymer tapered from 1.2 mm at the hub to 0.72 mm at the tip (equivalent to 22 gauge metal needle), with an ID/OD ratio of 70%. [16]

6. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   So a 1 / 2 in (12.7 mm) diameter drill will be able to drill a hole 4 + 1 / 2 in (114.3 mm) deep, since it is 9 times the diameter in length. A 1 / 8 in (3.175 mm) diameter drill can drill a hole 1 + 5 / 8 in (41.275 mm) deep, since it is 13 times the diameter in flute length. [3]

7. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, fine): For 7 ⁄ 16-20 (same diameter as the previous example, but this time with 20 threads per inch, which is considered fine), 0.437 in × 0.90 = 0.393 in (i.e., if the threads are to be fine, then a slightly larger diameter drill bit should be used before tapping the hole for the screw).