Search results
Results From The WOW.Com Content Network
The higher-order derivative test or general derivative test is able to determine whether a function's critical points are maxima, minima, or points of inflection for a wider variety of functions than the second-order derivative test. As shown below, the second-derivative test is mathematically identical to the special case of n = 1 in the ...
The second derivative test can still be used to analyse critical points by considering the eigenvalues of the Hessian matrix of second partial derivatives of the function at the critical point. If all of the eigenvalues are positive, then the point is a local minimum; if all are negative, it is a local maximum.
At the remaining critical point (0, 0) the second derivative test is insufficient, and one must use higher order tests or other tools to determine the behavior of the function at this point. (In fact, one can show that f takes both positive and negative values in small neighborhoods around (0, 0) and so this point is a saddle point of f.)
A derivative test uses the derivatives of a function to locate the critical points of a function and determine whether each point is a local maximum, a local minimum, or a saddle point. Derivative tests can also give information about the concavity of a function.
The ratio in the definition of the derivative is the slope of the line through two points on the graph of the function , specifically the points (, ()) and (+, (+)). As h {\displaystyle h} is made smaller, these points grow closer together, and the slope of this line approaches the limiting value, the slope of the tangent to the graph of ...
In mathematics, the comparison test, sometimes called the direct comparison test to distinguish it from similar related tests (especially the limit comparison test), provides a way of deducing whether an infinite series or an improper integral converges or diverges by comparing the series or integral to one whose convergence properties are known.
Thus, the derivative of a function called f is denoted by f′, pronounced "f prime" or "f dash". For instance, if f(x) = x 2 is the squaring function, then f′(x) = 2x is its derivative (the doubling function g from above). If the input of the function represents time, then the derivative represents change concerning time.
Definitions of the appropriate topologies on spaces of test functions and distributions are given in the article on spaces of test functions and distributions. This article is primarily concerned with the definition of distributions, together with their properties and some important examples.