Ads
related to: 1kw end fed hf antenna
Search results
Results From The WOW.Com Content Network
A dipole can be fed from very near its end (needing to be only about 1 / 20 th of the dipole length from the actual end) but the end impedances are exceedingly high – a few thousands of ohms, depending on the average height of the antenna and thickness of its wire.
An antenna such as the one described above is usable for both local and medium-long-distance communication across a frequency range of about 1:6 . For example, an antenna for the lower portion of shortwave (say, 3–18 MHz) will be roughly 33 m (110 feet) long, with conductors spaced 1 m (3.3 feet). For the higher portion of shortwave (5–30 ...
The latter factor is quantified by the antenna gain, which is the ratio of the signal strength radiated by an antenna in its direction of maximum radiation to that radiated by a standard antenna. For example, a 1,000 watt transmitter feeding an antenna with a gain of 4× (equiv. 6 dBi) will have the same signal strength in the direction of its ...
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
When the antenna is fed at some other point, the formula requires a correction factor discussed below. In a receiving antenna the radiation resistance represents the source resistance of the antenna, and the portion of the received radio power consumed by the radiation resistance represents radio waves re-radiated (scattered) by the antenna. [8 ...
The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.