Search results
Results From The WOW.Com Content Network
It is also why more than one overdrive gear is seldom seen in a vehicle except in special circumstances i.e. where high (numerical) differential gear is required to get the vehicle moving as in trucks or performance cars though double overdrive transmissions are common in other vehicles, often with a small number on the axle gear reduction, but ...
These "opposing" pressures caused the gear changes through the free-floating gear change valves. On October 18, 1967, the N360 AT model with the lock-up function was unveiled at the London Auto Show.(ref Honda Worldwide) It is not now clear if the lockup function made it into production; it was not fitted to the N600AT for Europe.
A semi-automatic transmission is a multiple-speed transmission where part of its operation is automated (typically the actuation of the clutch), but the driver's input is still required to launch the vehicle from a standstill and to manually change gears.
This page was last edited on 12 January 2010, at 17:35 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
It is fuel injected, has an aluminum-alloy cylinder block and cylinder head, is a SOHC 16-valve design (four valves per cylinder) and utilizes Honda's i-VTEC system. The R series engine has a compression ratio of 10.5:1, features a " drive by wire " throttle system which is computer controlled to reduce pumping losses and create a smooth torque ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Work Completed: Replaced gear knob, passenger door and door mirrors, pulled and filled dent in rear nearside quarter panel, repainted wheels and replaced the centre caps, applied new door sill decals, replaced handbrake lever, replaced handbrake warning light, adjusted rear exhaust section to prevent it from knocking against the undercarriage, fitted a new stereo, engine service including ...
The two clutches are placed one on the gearbox input shaft and the other on the gearbox output shaft. To make a gear change, both clutches disengage simultaneously and a brake inside the gearbox engages. The gearchange occurs with all gears stationary, so no synchronizing mechanism is needed. After the gear change, both clutches re-engage.