Ads
related to: stainless steel gas connector 1/4 inch male inverted flare to 1 4 inch npt- Standard Gas Springs
Huge Selection of Gas Springs
Control the motion of your lid
- SS Gas Springs
Stainless Steel Gas Springs to
withstand marine environments.
- Compression Dampers
Provides a controlled speed
by compressing the rod back in
- Small Gas Springs/Dampers
Low-pressure nitrogen gas springs
for lighter doors and compact fits.
- Gas Spring Mounting
Gas Spring Ball Studs and Brackets
in plain and stainless steel.
- Gas Springs & Dampers
Our broad array of gas springs and
dampers are easily searchable
- Standard Gas Springs
Search results
Results From The WOW.Com Content Network
JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.
The most common flare fitting standards in use today are the 45° SAE flare [2] [3],the 37° JIC flare, and the 37° AN flare. For high pressure, flare joints are made by doubling the tube wall material over itself before the bell end is formed. The double flare avoids stretching the cut end where a single flare may crack.
The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′. The standard for Nominal Pipe Size (often abbreviated NPS, which should not be confused with the abbreviation NPS for the straight thread form standard) is loosely related to the inside diameter of Schedule 40 series of sizes.
The iOverlander [2] database maintained by travelers, My LPG [3] and the Facebook group "Cooking Gas Around the World [4]" provide more information about individual sources per country. Much general information about global LPG use and standardization is available from the World LPG Association [ 5 ] and the AEGPL [ 6 ]
AN fittings are a flare fitting, using 37° flared tubing to form a metal-to-metal seal. They are similar to other 37° flared fittings, such as JIC , which is their industrial variant. [ 2 ] The two are interchangeable in theory, though this is typically not recommended due to the exacting specifications and demands of the aerospace industry.
POL is the common name for the standard CGA 510 (US Compressed Gas Association connection number). The Thread specification is .885" – 14 NGO – LH – INT, meaning 0.885 in (22.5 mm) diameter thread, 14 threads per inch (1.814 mm pitch), National Gas Outlet form, left-hand internal thread. [3]
Ad
related to: stainless steel gas connector 1/4 inch male inverted flare to 1 4 inch npt