Ads
related to: toilet water not shutting off pump control- $99 Sewer Drain Cleaning
Main Sewer Drain Line Clearing
Up To 100ft Or It's Free
- Sewer & Drain Services
Plumbing & Drain Cleaning Pros
Call Rescue Rooter.
- Expert Drain Services
Certified Drain Technicians
Same Day Service, Call Now
- $50 Off Plumbing Repairs
Any Service, Repair or Replacement
Call Now
- $99 Sewer Drain Cleaning
Search results
Results From The WOW.Com Content Network
Because the water is gradually shut off, slower water at the end of the cycle that will not activate the siphon serves to refill the bowl. The valve cannot be kept open by holding the flush lever in the activated position, wasting water, because this only sends the main cylinder valve all the way up to its topmost shut off position.
When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water - allowing the water to exit to the toilet bowl below, so that the tank may empty.
An isolation valve is a valve in a fluid handling system that stops the flow of process media to a given location, usually for maintenance or safety purposes. [1] They can also be used to provide flow logic (selecting one flow path versus another), and to connect external equipment to a system. [2]
Some normal water use conditions may cause short episodes of discharge (this is why check one has a minimum passing value of relief +3. It is designed to handle the pressure fluctuations). In the case of the upstream check valve passing, the differential pressure (higher supply pressure compared with the lower chamber pressure) causes any flow ...
A ball valve is a flow control device which uses a hollow, perforated, and pivoting ball to control fluid flowing through it. It is open when the hole through the middle of the ball is in line with the flow inlet, and closed when it is pivoted 90 degrees by the valve handle, blocking the flow. [1]
The handle moves up and down to control the amount of water flow and from side to side to control the temperature of the water. Especially for baths and showers, the latest designs are thermostatic mixing valves that do this using a built-in thermostat, and can be mechanical or electronic. There are also taps with color LEDs to show the ...