Search results
Results From The WOW.Com Content Network
A strut bar, strut brace, or strut tower brace (STB) is an automotive suspension accessory on a monocoque or unibody chassis to provide extra stiffness between the strut towers. With a MacPherson strut suspension system where the spring and shock absorber combine in one suspension unit, which also replaces the upper control arm, the entire ...
The Marine Multi-purpose Vehicle or MMPV is a 4x4 utility vehicle built by the Philippine Marine Corps. Similar in concept and appearance to the HMMWV , it was created to replace the M151 jeeps in service, which were becoming difficult to maintain due to a lack of available spare parts.
In 1920, Leyland Motors used torsion bars in a suspension system. In 1922, independent front suspension was pioneered on Lancia Lambda, and became more common in mass market cars from 1932. [8] Today, most cars have independent suspension on all four wheels. The part on which pre-1950 springs were supported is called a dumb iron.
The MacPherson strut is a type of automotive suspension system that uses the top of a telescopic damper as the upper steering pivot. It is widely used in the front suspension of modern vehicles. The name comes from American automotive engineer Earle S. MacPherson, who invented and developed the design.
Automotive suspension design is an aspect of automotive engineering, concerned with designing the suspension for cars and trucks. Suspension design for other vehicles is similar, though the process may not be as well established. The process entails Selecting appropriate vehicle level targets; Selecting a system architecture
A radius rod (also called a radius arm, torque arm, torque spring, and torsion bar) is a suspension link intended to control wheel motion in the longitudinal (fore-aft) direction. The link is connected (with a rubber or solid bushing ) on one end to the wheel carrier or axle , on the other to the chassis or unibody of the vehicle.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.