Search results
Results From The WOW.Com Content Network
Alternatively, a manifold vacuum sensor can be used. The manifold vacuum sensor signal, the throttle position, and the crankshaft speed can then be used by the engine control unit to calculate the correct amount of fuel. In modern engines, a combination of all these systems is used. [5]
Air-cooled engines are used in aircraft engine control and other air-cooled engines as in cars and air-cooled motorcycles. [1] A cylinder from an air-cooled aviation engine, a Continental C85. Notice the rows of fins on both the steel cylinder barrel and the aluminum cylinder head. The fins provide additional surface area for air to pass over ...
Absolute cylinder pressure is used to calculate the dynamic compression ratio, using the following formula: = where is a polytropic value for the ratio of specific heats for the combustion gases at the temperatures present (this compensates for the temperature rise caused by compression, as well as heat lost to the cylinder)
The shape of the combustion chamber, intake ports and exhaust ports are key to achieving efficient combustion and maximising power output. Cylinder heads are often designed to achieve a certain "swirl" pattern (rotational component to the gas flow) and turbulence, which improves the mixing and increases the flow rate of gasses. The shape of the ...
Pressure in cylinder pattern in dependence on ignition timing: (a) - misfire, (b) too soon, (c) optimal, (d) too late. In a spark ignition internal combustion engine, ignition timing is the timing, relative to the current piston position and crankshaft angle, of the release of a spark in the combustion chamber near the end of the compression stroke.
This was Chevrolet's second 4.3L power plant; four other Chevrolet engines displaced 4.3L: the Vortec 4300 (a V6 based on the Chevrolet 350 cu in (5.7 L), with two cylinders removed), the original 265 cu in (4.3 L) V8 in 1954, a bored version of the stovebolt-era 235 inline six displacing 261 cu in (4.3 L), and a derivative of the Generation II ...
The exhaust has dual effects on HCCI combustion. It dilutes the fresh charge, delaying ignition and reducing the chemical energy and engine output. Hot combustion products conversely increase gas temperature in the cylinder and advance ignition. Control of combustion timing HCCI engines using EGR has been shown experimentally. [13]
Aftermarket port fuel injection and re-engineered cylinder heads have been the norm, although parts for the inline-six, such as aftermarket intake manifolds (from a three-carburetor setup or a single 4-barrel carburetor), exhaust headers, and hybrid cylinder heads based on Chevrolet's small-block engine are costlier than those for the small ...