Search results
Results From The WOW.Com Content Network
For example, if a shaft with a nominal diameter of 10 mm is to have a sliding fit within a hole, the shaft might be specified with a tolerance range from 9.964 to 10 mm (i.e., a zero fundamental deviation, but a lower deviation of 0.036 mm) and the hole might be specified with a tolerance range from 10.04 mm to 10.076 mm (0.04 mm fundamental ...
Projected tolerance zone symbol (used in a feature control frame) In geometric dimensioning and tolerancing, a projected tolerance zone is defined to predict the final dimensions and locations of features on a component or assembly subject to tolerance stack-up.
no particular distribution (a "floating" zone) Tolerances for the profile symbols are equal bilateral unless otherwise specified, and for the position symbol tolerances are always equal bilateral. For example, the position of a hole has a tolerance of .020 inches. This means the hole can move ±.010 inches, which is an equal bilateral tolerance.
Tolerance stackups or tolerance stacks are used to describe the problem-solving process in mechanical engineering of calculating the effects of the accumulated variation that is allowed by specified dimensions and tolerances. Typically these dimensions and tolerances are specified on an engineering drawing.
Standard tolerance grades are a group of tolerances for linear sizes characterized by a common identifier. For SI measurements, a system of tolerance grades defined in ISO 286 is frequently used and identified by the letters IT followed by a number specifying how precise the requirements are, relative to the nominal size of a part.
Engineering fits are generally used as part of geometric dimensioning and tolerancing when a part or assembly is designed. In engineering terms, the "fit" is the clearance between two mating parts, and the size of this clearance determines whether the parts can, at one end of the spectrum, move or rotate independently from each other or, at the other end, are temporarily or permanently joined.
For premium support please call: 800-290-4726 more ways to reach us
The tolerance zone is made of twice the space between two parallel opposite planes spaced with tolerance value apart. The indication CZ implies that we shall apply location and orientation constraints between the tolerance zones. The value of the constraints are to be taken from the drawing using explicit or implicit theoretical exact dimensions.