Ads
related to: 124r tire rating scale printable forms 2 part
Search results
Results From The WOW.Com Content Network
UTQG ratings on sidewall of Toyo Tires Proxes R39 tire UTQG ratings (top) and tire code (bottom) on sidewall of Continental ContiProContact tire. Uniform Tire Quality Grading, commonly abbreviated as UTQG, is a set of standards for passenger car tires that measures a tire's treadwear, temperature resistance and traction.
Starting in 1972 tires were specified by load rating, using a letter code. In practice, a higher load rating tire was also a wider tire. In this system a tire had a letter, optionally followed by "R" for radial tires, followed by the aspect ratio, a dash and the diameter – C78-15 or CR78-15 for bias and radial, respectively. Each diameter of ...
The wet grip index (WGI) is calculated from the results of two tests specified in the regulations. The first test measures the maximum achievable average deceleration of a vehicle as it slows from 85 ± 2 km/h (52.8 mph) to 20 ± 2 km/h (12.4 mph). The second test (the "skid trailer" test) is usually performed using a tow vehicle and trailer.
This page was last edited on 30 November 2013, at 17:10 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike License 3.0; additional terms may apply.
When measured by using these standard test practices, most new passenger tires have reported RRCs ranging from 0.007 to 0.014. [2] In the case of bicycle tires, values of 0.0025 to 0.005 are achieved. [3] These coefficients are measured on rollers, with power meters on road surfaces, or with coast-down tests.
From observation: it seems that the higher the first 3 digits are, the taller (greater diameter) the tire; and the lower the next 2 digits, the wider the tire. This observation is not correct. From the explanation:-for instance 265/70R17-The width is 265mm and the height is 185.5mnm (70% of width) and fits a 17" rim.
The inner width of the rim on which the tire is mounted should be about 65% of the tire's nominal section width for tires smaller than 30 mm and 55% for those larger. The section height of a tire is usually identical to its section width (for tires less than 28 mm, 2.5 mm have to be added to the width to get the height).
Colorized tire footprint pressure distribution. The contact patch is the portion of a vehicle's tire that is in actual contact with the road surface.It is commonly used in the discussion of pneumatic (i.e. pressurized) tires, where the term is used strictly to describe the portion of the tire's tread that touches the road surface.