Ads
related to: what size lamp for sideboard bedroom floor light fixtures replacement parts
Search results
Results From The WOW.Com Content Network
Lamp harp with fluorescent bulb. A lamp harp is the component of a lamp to which the lamp shade is attached. It typically comes in two separate parts, a saddle which is fastened under the lamp socket, and the harp itself which consist of a lightweight frame attached to the saddle at its lower end and extending upwards to a point above the bulb.
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
Mogul bi-post (G38) can handle up to 100 amps and is used with searchlights and film & stage lighting fixtures of 1000 watts or larger. Incandescent, halogen and HMI light sources use this design. Medium bi-post (G22) is used with film & stage lighting fixtures between 250 and 1000 watts. Mini bi-post (G4-G6) Common types:
The compact size of the MR base allows for much smaller, more discreet fixtures than the incandescent reflector bulbs that pre-dated MRs. The reflector controls the direction and spread of light cast from the lamp. MR lamps are available with different beam angles from narrow spot lights of as small as 7° to wide flood lamps of 60°.
A balancing arm (the forearm) has on one side of an axis a small counterweight and on the other side a lamp cap. These parts are lifted by a second bigger balancing arm (the upper arm) that has on the other side of a second axis a heavier counterweight. The lamp designed by Edouard-Wilfrid Buquet in 1927 works in this way.
The large E39 "Mogul" and E40 "Goliath" base are used on street lights, and high-wattage lamps (such as a 100 W / 200 W / 300 W 3-way) and many high-intensity discharge lamps. In areas following the U.S. National Electrical Code , general-use lamps over 300 W cannot use an E26 base and must instead use the E39 base.